by Detailed Infinity » Thu Mar 13, 2014 6:46 pm
Yes Eric specifies >1amp and as you say driving the YuangJing 6N3 board's pre-amp valves heaters in the unit would need surplus current re amperage so that heat doesn't become a problem with the supply.
I'm thinking of putting in a transformer with 12v AC output with sufficient amperage and inputing to a male 3 pin C16 in the chassis case which I've got lying around. Mains straight in then. There's plenty of room in the enclosure to accommodate one. Would that be a problem Eric?
Bri
Last edited by Detailed Infinity on Fri Mar 14, 2014 1:46 pm, edited 1 time in total.