The illuminator first...
Buy a pack of Powerbronze Power Rods in white... (
http://www.powerbronze.co.uk/onlineshop.aspx) Two strips in each pack, and you only need one... sell the spare one on here!
Here's one with the end shrink tape carefully removed...
It's adhesive backed, so, after deciding exactly where you want it, place it like this...
Note the washers over the original bolt holes? They allow a little clearance for the wires to pass through. A little double sided tape holds then in place
The Power Rods are 12volt affairs - white positive, black negative, so look for this terminal block, where a switched supply is available and carefully trim you wires - with plenty to spare : it's a pain to do - and add white to red, black to black in the terminal block.
And the first job is done... reassemble and switch on ...