Greetings everyone,
My Low/Dry output is very low (faint) even when the FET level control is at maximum. The wet output works fine. I removed the daughter board and used a dual jumper as explained in Piet's build instructions to test it as guitar preamp and the result is the same. I checked the IC voltages again as per Piet's instructions and they measure correctly. Being non technical I am not sure what else to check apart for bad wiring connections from the board to the dry/wet output which I have done. To be honest the problem has happened before and usually went away after I plugged the output cable from the unit into the guitar into the wet output and then back into the dry/wet output. To check for a faulty output socket I swapped the output wiring over to the change the sockets and the problem went with the swap. i.e the dry/wet output was still very low so the socket is not fault. Any suggestions would be great. Cheers, John