Page 1 of 1

eTap2hw version v2, newbuild with retrofits

PostPosted: Sun May 03, 2015 2:20 pm
by Echotapper
A small addition that seems trivial are the new solderpins added to the original motherboard. This 1 cent feature allows for the resistors required for the FET transistors to be soldered in a way that they can be replaced when optimalisation of the FET is to be carried out. This is part of the v2 version that incorporates most of Steve's developed improvements to my design. When ordering a kit from Newtone make sure to add the low-cost v2 kit to your order. Instructions to build are also available.

Piet

Image