Anything to do with Fender, Burns and other guitars; also amps, effects units including eTap, plus any other music making accessories
Moderators: David Martin, dave robinson, Iain Purdon, George Geddes
by buckshot » Thu Jun 10, 2010 2:54 am
G'day All,
Just a quick Q about my 67 AC 30 TB. Maybe some one can help. When I switch it on I get a slight crackle sound and then when I plug in the guitar lead no volume comes. Sometimes when I turn the vol. up full and pull it back it starts to operate normally. Then sometimes if I switch the amp on and off a couple of times it also starts. I have checked all the valves and have sprayed CO Contact spray all around the place. Any ideas what the problem might be?
regards
Buckshot
-
buckshot
-
by RUSSET » Thu Jun 10, 2010 7:06 am
Could be a dodgy jack plug connection ? Check out the wiring in the plugs.
Tony.
-
RUSSET
-
by David Martin » Thu Jun 10, 2010 7:48 am
How did you check the valves, Tom? My understanding is that you need to substitute for a known good valve one at a time...
David M
-
David Martin
- Site Admin
-
- Posts: 1868
- Joined: Tue Sep 08, 2009 4:48 pm
- Location: Lincoln
- Full Real Name: David Martin
-
by buckshot » Sat Jun 12, 2010 9:56 am
Thanks Tony & Dave. It happens in all plugs so it's not just one. The valves I put in are new( well, 6 months ago) .I put in a matched quad lot of well known brand. I thought maybe it might be the on/off switch?
regards
Buckshot
-
buckshot
-
by David Martin » Sun Jun 13, 2010 8:37 am
Some valves give out after only 6 months... check the GZ...
David M
-
David Martin
- Site Admin
-
- Posts: 1868
- Joined: Tue Sep 08, 2009 4:48 pm
- Location: Lincoln
- Full Real Name: David Martin
-
Return to Gear
Who is online
Users browsing this forum: No registered users and 61 guests