Malcocaster

by **ecca** » 18 Sep 2011, 19:13

Wonderful ! Thanks a million..... again.

by **ecca** » 25 Sep 2011, 19:03

Grrrrrrrrrrrrrrr !!!!!!!!!!

by **Paulps** » 26 Sep 2011, 14:23

ecca wrote:Grrrrrrrrrrrrrrr !!!!!!!!!!

????????

by **noelford** » 26 Sep 2011, 14:51

Can I help?!

by **ecca** » 26 Sep 2011, 15:18

I did the transfer.... in the end, it looks lovely, thanks for instruction and all your help Noel
I carefully knocked in tiny, tichy little pin one OK.
I carefully knocked in pin two, OK.
First tap at pin three and it fled off at 300mph into the stratosphere never to be seen again.
GGRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRR

by **ecca** » 26 Sep 2011, 15:48

Here's the finished thing, the edges look tatty in this picture.
I had a new camera , Canon 600D, miles too sharp a picture.
Ah well.
Thanks all.
PS I had a set of gold knobs and a selector switch tip from America, looks really swish now.

malc.jpg: (237.51 KiB) Downloaded 5357 times

by **noelford** » 26 Sep 2011, 16:16

Looks good, especially considering I did the BURNS lettering by hand because I couldn't find a suitably correct font!

by **Paulps** » 26 Sep 2011, 16:36

ecca wrote:
First tap at pin three and it fled off at 300mph into the stratosphere never to be seen again.
GGRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRRR

It will no doubt re-enter in due course. Ask NASA to trace it. They might have more success than they did with the recent satellite. :twisted: